Home
Drywall sheet calculator
A planning count for a rectangular room. It uses a 4 by 8 foot sheet, or a 1.2 by 2.4 meter sheet, and states the other allowances in the formula.
These fields start with a sample so you can check the arithmetic. Replace them with your own figures.
How to use it
Measure length, width, and wall height in one unit system. Door and window areas start at common sizes. Leave the ceiling off unless you are hanging board there too.
Waste covers cuts and a broken sheet. The screw, tape, and compound lines are planning rates, not a brand’s coverage chart. Price the labor on Handyman job estimate or the hourly rate on Contractor billable-hour rate.
Formula
Wall area = 2 × (length + width) × height. Net area = wall area − openings + ceiling, and it cannot go below zero. Area with waste = net × (1 + waste ÷ 100). Sheets = that area ÷ 32 square feet, or ÷ 2.88 square meters, rounded up. Screws = sheets × 32. Tape = sheets × 16 feet, or × 4.8 meters. Compound = waste-adjusted area ÷ 100 square feet per gallon, or ÷ 2.5 square meters per liter.
Worked example
Questions
Why might I need more sheets than this?
A 4 by 8 sheet wastes more in a short hallway, and a lid or a bulkhead is not part of the box. Add those areas yourself, or raise the waste percent.
Does this include backing or corner bead?
No. It counts board, a screw allowance, tape, and compound. Corner bead, nails for the bead, and screws for backing are separate.
Which way do the sheets hang?
The count does not care. Hanging them horizontally or vertically changes the cuts, not the net area. Waste is where you allow for the cuts.
Is the compound figure for three coats?
It is one planning rate for a normal taped finish: about one gallon per 100 square feet. A heavy texture uses more. Read the bucket if you already bought it.